Uncategorized

Entries with no category

  1. Scratch Building HMS Leopard Part 7

    Rewind and Take Two on the Nelson Chequer and Stepping the Main Mast

    Another busy day, not much time for model work. But I managed to do a little here and there throughout the day (between spurts of real work).

    I decided that I didn't like the hand painted gun ports. So, I painted back over them with the yellow paint.

    I also added some white to the stern area of the ship where the windows will be applied. The reason for the white is that I am using ...

    Updated 09-20-2013 at 21:48 by Wear Ship Dave

    Categories
    Uncategorized
  2. Scratch Building HMS Leopard Part 6

    Painting and Detailing, continued

    I didn't have a lot of time to spend today, so a small update this evening.

    I began with the yellow bands. I did them free hand... Working in this scale, I suddenly realize that my hands aren't as steady as I thought they were! But these are passable. I've intentionally left the rear quarter of the ship for now. I'm still contemplating how I want to do the windows, so I'm keeping my options open for now.

    Name:  IMG_1607.JPG
Views: 13786
Size:  638.3 KB ...
    Categories
    Uncategorized
  3. Scratch Building HMS Leopard Part 5

    Initial Painting and The Cannon Foundry

    Today, I gave the ship some color. I started with three coats of acrylic floor finish to seal the balsa a little. Then a couple coats of black on the hull, a light tan on the decks, and a medium brown on the inside of the rails. I cut some hatch covers/grates from card stock and glued them in place, giving them the medium brown color.

    I still need to add the yellow bands on the hull, maybe tomorrow.

    Name:  IMG_1596.jpg
Views: 13719
Size:  640.0 KBName:  IMG_1597.jpg
Views: 13947
Size:  676.8 KB ...

    Updated 09-17-2013 at 21:17 by Wear Ship Dave

    Categories
    Uncategorized
    Attached Thumbnails Attached Images  
  4. Scratch Building HMS Leopard Part 4

    Adding the Rail and some Detail

    I had a few minutes to spare this afternoon. I wasn't liking the strip of card stock that I added to the bow of the ship. It was too square... So I put a new blade into the X-Acto knife and went to work. (I wanted a REALLY sharp blade)

    Very important to draw the blade through the paper here, let the edge of the blade "saw" through it on a microscopic level. If you try to just push the blade through the paper, it will tear ...

    Updated 09-16-2013 at 23:34 by Wear Ship Dave

    Categories
    Uncategorized
  5. Scratch building HMS Leopard, Part 3

    Hull Construction
    I started by choosing a couple of points that I could precisely locate that also passed through all of the decks I am using for reference.

    The purpose? To align the decks correctly, one above the next.

    Points chosen, I used a basic hat pin to pierce each deck in the correct location. You'll see that I have a lump of modeling clay underneath my deck shape. This supports the card stock shape and makes it much easier to push the pin through ...
    Categories
    Uncategorized
Page 1 of 2 12 LastLast